Design Questions Set 3:
Find the type of weld joint the following diagram is representing.
Solution:
Find the width of the cross piece if the outer diameter of the hook bearing is 160 mm.
Solution:
In Multi-Body Dynamics, the reciprocal of stiffness is called:
Solution:
Advantages of smaller pressure angles in gears are:
Solution:
A solid circular shaft needs to transmit 50 Nm torque allowable shear stress of the material is 40 MPa.
assuming F.O.S.= 2. Calculate the diameter of the shaft (in mm )?
Solution:
Which types of bearings, as their name suggests, have no lubricant present between the contact layers?
Solution:
Which of the following is the condition in which we prefer oil-type lubricated bearings over grease-type lubricated bearings?
Solution:
An element at the critical section of the component under the stress conditions has two principal stresses: σx = 60 MPa and σy = 60 MPa, with τxy = 0. The maximum working stress according to the Maximum Shear Stress Theory is:
Solution:
Find the belt speed of a belt conveyor system given the following data:
Design capacity: 220 tons per hour (TPH)
Material density: 0.7 tons per cubic meter (T/m³)
Minimum belt width: 800 mm
Idler factor 'c': 460 for a troughing angle of 20°
Solution:
The phases of design morphology include problem definition, concept generation, and concept evaluation. Which phase of design morphology do these activities belong to?
Solution:
Related Question Sets:
Related Topics:
Scroll to Top
