Machining-and-machine-tool-operations Questions Set 30:
What type of surface is produced in taper turning?
Solution:
The part of a cutting tool where the cutting edge is formed is known as the:
Solution:
In which of the following manufacturing operations are jigs preferred over fixtures?
Solution:
Power consumption during cutting operation on lathe for a cutting force of 70 N and cutting speed 5 m/s is _____ (in watt).
Solution:
A single point thread cutting tool should ideally have a:
Solution:
The EMF process allows increased ductility for which type of alloys?
Solution:
In a machining operation, if the generatrix and directrix are both straight lines, the surface obtained is:
Solution:
For maximum power delivery in an EDM setup, the Discharge Voltage (Vd) should be related to the Supply Voltage (V) as:
Solution:
What is the need for non-traditional manufacturing?
Solution:
Which of the following methods can be used to increase tool life?
Solution:
Related Question Sets:
Related Topics:
Scroll to Top
