200+ Metrology-and-inspection Questions

Metrology-and-inspection Questions Set 12:

Quiz Mode

Find the full-scale output for an 8-bit DAC with a range of 0-10V.

39.06V

9.961V

5.556V

Solution:

The type of fit associated with fasteners is:

Transition Fit

Clearance Fit

Interference Fit

None of the above

Solution:

First-order surface irregularity is caused by?

Feed and speed

Lack of straightness

Vibrations

Lack of rigidity

Solution:

On which principle does the Bernoulli flow meter work?

Differential pressure

Mechanical linkage

Ionization

Vacuum

Solution:

On what principle does the magnetic flow meter operate?

Apparent change in velocity

Ionization

Ohm's law

Faraday's law

Solution:

Which of the following is included in the analytical checking of gears?

checking of noise level

checking of tooth profile

checking of vibrations

none of these

Solution:

To which limit condition is the 'Go' limit applied?

Maximum material limit

Minimum material limit

Lower limit of shaft and upper limit of hole

Moderate material limit

Solution:

In which of the following sampling plans is the maximum data handling analysis load observed?

Sequential sampling plan

Single sampling plan

Double sampling plan

None of these

Solution:

Which of the following statements about systematic and random errors is/are true?

Systematic errors are caused due to system interaction errors.

Gross errors are known as compensating errors.

All of these.

Probability laws are followed by random errors.

Solution:

Which of the following statements about an Inverse Transducer is not true?

An example of an Inverse Transducer is a piezoelectric crystal.

It is a device that converts a non-electrical quantity into an electrical quantity.

It is used in a control system to control various process parameters such as pressure, temperature, displacement, etc.

All of the above

Metrology-and-inspection Questions Set 12:

Find the full-scale output for an 8-bit DAC with a range of 0-10V.

Solution:

The type of fit associated with fasteners is:

Solution:

First-order surface irregularity is caused by?

Solution:

On which principle does the Bernoulli flow meter work?

Solution:

On what principle does the magnetic flow meter operate?

Solution:

Which of the following is included in the analytical checking of gears?

Solution:

To which limit condition is the 'Go' limit applied?

Solution:

In which of the following sampling plans is the maximum data handling analysis load observed?

Solution:

Which of the following statements about systematic and random errors is/are true?

Solution:

Which of the following statements about an Inverse Transducer is not true?

Solution:

Related Question Sets:

Related Topics: