Metrology-and-inspection Questions Set 8:
What type of pressure is measured using a McLeod gauge?
Solution:
To make an angle gauge block, which of the following materials is/are used?
Solution:
The profile of a gear tooth can be checked using which of the following instruments?
Solution:
Using a tool maker's microscope, which of the following components are inspected?
Solution:
The linear relation between cumulative pitch error and length of thread is shown by?
Solution:
Which of the following instruments is used to measure the internal diameter of a workpiece?
Solution:
Calculate the percentage error expressed as a percentage of full-scale reading if the expected value of the voltage across a resistor is 80V and the measured value is 79V.
Solution:
What is the least count of the clinometer used to check the reading of column rotation for setting the helix angles in a universal micrometer?
Solution:
For interference fit, which of the following is true?
Solution:
How can the output voltage swing of an op-amp comparator be kept within specific limits?
Solution:
Related Question Sets:
Related Topics:
Scroll to Top
